SpeedyBee F745 35A BLS 25.5x25.5 AIO Flight Controller

US$115.99
SKU:
SB-F7-35A-AIO
Shipping:
Free Shipping
Write a Review
Important Note:
Make sure the AIO's slightly bigger size can fit your own quad! The size of this AIO is 36.5(L)*36.5(W)*7.0(H)mm.
We suggest you use this AIO on your 3.5" to 5" cinewhoops/long-range or lightweight quads.For quads below 3.5",
you should carefully check if your quad has enough room for this AIO.
 
 
SpeedyBee F745 35A AIO
SpeedyBee F745 35A AIO
SpeedyBee F745 35A AIO
SpeedyBee F745 35A AIO
SpeedyBee F745 35A AIO
SpeedyBee F745 35A AIO
SpeedyBee F745 35A AIO
SpeedyBee F745 35A AIO
SpeedyBee F745 35A AIO
SpeedyBee F745 35A AIO
Specifications
Overview
Product Name SpeedyBee F745 35A BLS AIO
Power Input 3S - 6S Lipo
Mounting 25.5 x 25.5mm, 3mm hole diameter
Dimension 36.5mm(L) x 36.5mm(W) x 7mm(H), recommended for quads at 3.5" or above
Weight 10.1g
FC
MCU STM32F745
IMU(Gyro) MPU6000
USB Connection Need to solder a USB TYPE-C module to D+,D-,GND pads.
Barometer BMP280
OSD Supported
BLE Bluetooth Supported. Used for parameter configuration,built-in a single 2.4 GHz Wi-Fi-and-Bluetooth combo chip
Flash FC Firmware Wirelessly Supported
Download/Analyze Blackbox Supported
DJI Air Unit 6-pin Connector Built-in.
Flash(for BlackBox) 8MB
Current Sensor Supported. Scale=256
BetaFlight Camera Control Pad Yes(CC pad)
5V Output 4 groups of 5V output. The total current load is 2.5A.
9V Output None
ESC Signal Pads M1 - M4
UART Full UART * 4(UART1, UART2, UART3,UART4)
ESC Telemetry UART None
I2C Supported.
LED Pad Used for WS2812 LED
Buzzer BZ+ and BZ- pad used for 5V Buzzer
BOOT Button Used to enter DFU mode
RSSI Input Not supported
SmartPort Not Supported
Supported Flight Controller BetaFlight(Default)
Firmware Target Name SPEEDYBEE F745AIO
ESC
Power Input 3-6S LiPo
Continuous Current 35A * 4
Burst Current 45A(5seconds)
ESC Protocol DSHOT300/600
Power Output VBAT
Current Sensor Supported(Sacle=256)
Firmware BLHeli_S JH40